
Base System Configuration
# P0602477 Ver: 3.1.11 Page 153
#
# maxCacheLoadSize <size in Kilobytes>
#
# Sets the maximum number of pages in a single cache load request.
# Max Pages = (max size in kilobytes) / (size of a single VDM page in kilobytes)
# Range of values is 2, 3, 4, ..., 100.
# Default = 32
#
# maxCacheLoadSize 32
#
# setSvcParam <param>=<value>
#
# Sets a service parameter for CCM/TMS.
#
# Available parameters
# ====================
# cpdMinSil >= 3000ms and <= 86400000ms
# Sets the minimum amount of silence required for the CPD resource to generate a
# SILENCE event.
#
# defLineState Busy or NoAnswer (Default Busy)
# Sets the default state between calls for CCM and the phone line resource.
#
# discguard 5s - 10m, or 0 to disable (Default 5m)
# The maximum time CCM will wait for all outstanding responses to be received
# before it will force the disconnect sequence to complete
#
# discstrip >= 0ms (Default 0ms)
# Sets the amount of data to strip from the end of a recording that is terminated
# by the caller hanging up (disconnect).
#
# dtmfguard ON or OFF (Default OFF)
# Used to turn touch tone validation in TMS on or off.
#
# dtmftonedur 40ms - 2040ms (Default 40ms)
# The minimum duration a touch-tone must exist for before the TMS considers
# it to be valid.
#
# first 2s - 86400s (Default 10s)
# Sets the maximum amount of time allowed for a caller to enter the first
# touch-tone in an input sequence (first character timeout).
#
# firstsil 0ms - 20400ms (Default 0ms)
# Sets the amount of silence required to abort a record on first silence
# detection (before voice starts). This parameter only applies to synchronous
# recordings.
#
# inter 2s - 86400s (Default 10s)
# Sets the maximum amount of time allowed for a caller to pause in-between
# touch-tones in a multiple tone input sequence.
#
Example: ccm_phoneline.cfg Sheet 3 of 4
Kommentare zu diesen Handbüchern