
120 Chapter 9 Configuring telephony resources
NN40020-603NN40020-603
Configuration
*Call signaling Direct
Gatekeeper Resolved
Gatekeeper Routed
Gatekeeper Routed no RAS
Direct: call signaling information is passed directly between
endpoints. The remote gateway table in the Element
Manager defines a destination code (digits) for each remote
system to direct the calls for that system to route. In each
system, the Nortel IP Terminals and H.323 Terminals
records map IP addresses to specific telephones.
Gatekeeper Resolved: all call signaling occurs directly
between H.323 endpoints. This means that the gatekeeper
resolves the phone numbers into IP addresses, but the
gatekeeper is not involved in call signaling.
Gatekeeper Routed: uses a gatekeeper for call setup and
control. In this method, call signaling is directed through the
gatekeeper.
Gatekeeper Routed no RAS: Use this setting for a
NetCentrex gatekeeper. With this setting, the system routes
all calls through the gatekeeper but does not use any of the
gatekeeper Registration and Admission Services (RAS).
Enable H245 tunneling <check box> If Enabled, the VoIP Gateway tunnels H.245 messages
within H.225. The VoIP Gateway service must be restarted
for a change to take effect.
Default: Disabled.
Primary Gatekeeper IP <IP address> If Gatekeeper Routed, Gatekeeper Resolved or Gatekeeper
Routed no RAS are selected under Call Signaling, type the
IP address of the machine that is running the gatekeeper.
Backup Gatekeeper(s) <IP address>
<IP address>
NetCentrex gatekeeper does not support RAS; therefore,
any backup gatekeepers must be entered in this field.
Note: Gatekeepers that use RAS can provide a list of
backup gatekeepers for the end point to use in the event of
the primary gatekeeper failure.
Table 22 H323 Settings fields (Sheet 3 of 5)
Field Value Description
Kommentare zu diesen Handbüchern