Avaya I2004 Betriebsanweisung PDF herunterladen (Seite 13)

Page 13

The default entry for each parameter will be displayed on the screen (see Figure

7).

NOTE: Some versions of the i2004 begin with the prompt ‘SET IP’. You will then

be asked to edit or accept all of the parameter information in the table on page

14. The last parameter prompt will be ‘DHCP?’. In this situation, you should enter

‘0’ – the set will then display ‘Locating server’ (see Figure 8 and go to the

instructions that follow it).

Figure 7

On most i2004 sets, you are first prompted to set DHCP parameters.

If the i2004 will use DHCP, enter a ‘1’ on the keypad. You will be asked to

indicate the level of DHCP use; enter ‘0’ for full DHCP (parameters will be set

automatically) or ‘1’ for partial DHCP (parameters will be partially entered). Once

parameters are entered, ‘Locating server’ will appear on the display (see Figure

8 and go to the instructions that follow it).

If the i2004 will not use DHCP, enter a ‘0’ on the keypad. You will be prompted

to set all necessary parameters manually.

As you enter parameters manually, use the BkSpace or Clear softkeys to edit the

default entry. BkSpace will delete each character as the key is pressed. Clear will

delete the entire entry.

Enter requested information in the menu fields by pressing the number keys on

the dialpad. Press the * key to enter a period (".") when entering the set's IP

address.

OK BkSpace Clear Cancel

Manual Cfg

DHCP? (0-No, 1-Yes)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Keine Kommentare

Avaya I2004 Betriebsanweisung Seite 13