Chapter 24 Replacing an internal component 203
Installation and Maintenance Guide
Figure 82 Hard disk and bracket assembly
3 Place the new hard disk in the hard disk bracket.
4 Use the four hard disk bracket screws to secure the hard disk to the bracket.
5 Set the hard disk and bracket in the main unit. See the figure Cable routing on page 205.
Make sure that the hard disk cable and power cable are routed properly. Route the power cable
under the bracket and loop the hard disk cable as shown.
Caution: Use only the screws that you removed from the hard disk in the
procedure To remove the hard disk on page 199. Using other screws can damage
the hard disk.
Hard disk bracket
Hard disk
Hard disk cable
Power cable
Hard disk/power
cable connector
Hard disk bracket screws
Hard disk bracket screws
Kommentare zu diesen Handbüchern