Avaya Configuring Dial Services Bedienungsanleitung Seite 81

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 426
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 80
Dial Services Overview
117353-A Rev. A 2-7
In Figure 2-3, three circuits share two physical lines that make up Demand pool 1.
Note that only two of the circuits using Demand pool 1 can be active
simultaneously because only two modems are available. The IP addresses are
associated with each circuit, not with the physical line.
In addition to assigning a demand pool ID to each circuit, you can assign protocol
interfaces and configure phone lists for use with V.25bis, Hayes, and ISDN
signaling. Refer to Chapter
12 for more information.
Demand Circuit Protocols
The protocol for a demand circuit can be either PPP or Frame Relay. A Frame
Relay demand circuit may have any number of service records and PVCs.
Typically, Frame Relay connections are used with ISDN lines. PPP and Frame
Relay circuits can use the same demand pool.
Figure
2-3 shows an example of a PPP demand circuit over modem lines. Figure
2-4 shows a Frame Relay demand circuit over ISDN lines.
Figure 2-4. Dial-on-Demand Connection over a Frame Relay Network
Router A
Router B
Router C
DS0033A
Router D
Frame Relay network
Frame
Relay
switch
Frame
Relay
switch
Frame
Relay
switch
Frame
Relay
switch
T1/HSSI/SYNC
BRI
PRI
Raise DTR/V.25bis
MODEM
Key
Leased line
Dial-up line
Seitenansicht 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 425 426

Kommentare zu diesen Handbüchern

Keine Kommentare