Avaya a System Processor Card in the Passport 5430 Multiservice Access Bedienungsanleitung PDF herunterladen (Seite 50)

Installing a System Processor Card in the Passport 5430 Multiservice Access Switch

4-8

306311-A Rev 00

Connect the DB-9 end of the cable to the communications data port on

the back of the laptop PC.

Connecting a Terminal Console

To connect a terminal console to the Passport 5430, make sure that you have the

RJ-45 to DB-9 cable (Order No. AA0011026) that Nortel Networks shipped with

the Passport 5430 and a DB-9 to DB-25 adapter (not supplied), then complete the

following steps:

Turn on and configure the terminal, using the parameters in Ta ble 4-2

and the terminal user guide.

Route the cable through the cable loom slot corresponding to PCI slot 1.

For instructions, see Installing and Operating the Passport 5430 Multiservice

Access Switch.

Insert the RJ-45 receptacle end of the console cable into the Passport

5430 Console connector.

For pin assignments, see Installing and Operating the Passport 5430

Multiservice Access Switch.

Attach the DB-9 receptacle connector to the DB-9 end of the adapter.

Table 4-2. Console Parameters

Parameter Value

Baud rate 9600

Data bits 8

Stop bits 1

Parity None

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

Keine Kommentare

Avaya a System Processor Card in the Passport 5430 Multiservice Access Bedienungsanleitung Seite 50