Avaya BCM450 Konfigurationsanleitung PDF herunterladen (Seite 28)

AT&T IP Flexible Reach

Nortel BCM450 Release 1.0 SIP Configuration Guide

*Nortel, Nortel Networks, Nortel (Logo), the Globemark, CS1000 are trademarks of Nortel Networks.

Issue 0.4 Page 28 of 33

instances of the BCM Monitor application can be used on a single PC to monitor

several remote BCM systems at the same time.

Backward version compatibility is supported.

All of the registered IP devices can be viewed with the BCM Monitor. The screen

shot below depicts IP Phone type, DN number and IP address of each registered

IP phone. Additionally, if the device is active on a call the RTP session

information is also displayed.

Figure 21: IP Device Listing

The end-to-end RTP sessions per IP call can also be displayed with the BCM

Monitor. The example below depicts an end-to-end call.

Figure 22: RTP Session Information

The BCM Monitor can be used to monitor incoming and outgoing trunks to

determine if trunks are being busy or if they are idle. The example below depicts

utilized lines used by local and remote telephone/DN numbers.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

Avaya BCM450 Konfigurationsanleitung Seite 28