
Enabling AppleTalk Services
114048 Rev. A 3-9
3.
Enter the appropriate IP address (using dotted decimal notation) in the
Local IP Address field.
4. Click on OK to exit the window and save your changes when you are
finished.
Parameter: Enable
Default: Enable
Options: Enable | Disable
Function: Enables or disables AURP on the router.
Instructions: Set to Enable to globally enable AURP.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.2
Parameter: Local IP Address
Default: None
Options: Any valid 32-bit IP address in dotted decimal notation
Function: Identifies an IP interface on the router. This is the IP interface used for
AURP.
Instructions: Enter the IP address of the interface on this router that AURP should use.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.5
To configure the AURP connection, enter the IP address for the remote peer. To do
this, begin at the Configuration Manager window and proceed as follows:
1. Select Protocols > AppleTalk > AURP > Interfaces.
The AT AURP Interface Configuration window appears (Figure
3-5).
Kommentare zu diesen Handbüchern