Avaya Configuring Ethernet, FDDI, and Token Ring Services Bedienungsanleitung PDF herunterladen (Seite 59)

Site Manager Line Services Parameters

117020-A Rev. A A-3

Parameter: Hardware Filter

Path: Conﬁguration Manager > XCVR Connector (10Base-T only) > Edit Line >

Edit CSMA/CD Parameters

Default: Disable (the default changes to Enable when, while adding the circuit , you

reply OK to the prompt

Do you want to enable Hardware Filters on this circuit?)

Range: Enable

| Disable

Function: Enables ﬁltering hardware in the link or net module to drop local frames at the

interface instead of copying them into system memory. Enabling hardware

ﬁlters improves bridging software performance because router resources are not

used to receive and reject local frames.

Instructions: Set to Enable only if you enabled the bridge software and the link or net module

has hardware ﬁlters.

MIB Object ID: 1.3.6.1.4.1.18.3.4.1.1.29

Parameter: BofL Retries

Path: Conﬁguration Manager > XCVR Connector > Edit Line > Edit CSMA/CD

Parameters

Default: 5 retries; 4 when the interface is conﬁgured for router redundancy

Range: 1 to 60 retries

Function: Speciﬁes the number of BofL messages this interface retransmits before the

router declares the circuit down.

Instructions: Either accept the default of 5 BofL retries, or specify a value from 1 to 60

retries. Use this parameter in conjunction with BofL Timeout Divisor and BofL

Timeout to decrease or increase the time it takes the router to declare an

interface down.

MIB Object ID: 1.3.6.1.4.1.18.3.4.1.1.59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 81 82

Keine Kommentare

Avaya Configuring Ethernet, FDDI, and Token Ring Services Bedienungsanleitung Seite 59