Avaya Configuring SMDS Bedienungsanleitung PDF herunterladen (Seite 32)

Configuring SMDS

2-10 117361-A Rev. A

To conﬁgure multigroup, follow these steps:

1. In your SMDS conﬁguration parameters, enter addresses in the Group

Address, ARP Address, and Individual Address parameters described in

Cha

pter 3 of this book.

2. In your IP interface conﬁguration, enter the same addresses that you

entered in the SMDS parameters in the previous step.

The equivalent IP parameters are SMDS Group Address, SMDS ARP Req

Address, and MAC Address. Refer to Conﬁguring IP Services for information

about these IP parameters.

3. Add a new IP interface with a unique IP subnetwork address. This

address should include a network/subnet and host address.

4. Enter a new Group Address, ARP Address, and Individual Address for

this new IP interface.

The IP interface parameters override these same parameters in the SMDS

conﬁguration for this and subsequent IP interfaces.

Conﬁguring Synchronous Lines for SMDS

If you enable SMDS on a circuit, Site Manager automatically sets the following

synchronous line parameters.

For more information about these parameters, refer to Conﬁguring and Managing

Routers with Site Manager.

Table 2-1. Synchronous Line Parameter Settings for SMDS

Parameter Value

BOFL Disable

Promiscuous Enable

Service Transparent

WAN Protocol SMDS

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Keine Kommentare

Avaya Configuring SMDS Bedienungsanleitung Seite 32