Avaya SRM Link Modules in BN Platforms Bedienungsanleitung PDF herunterladen (Seite 27)

115622-A Rev. A 3-1

Chapter 3

Checking Status Indicators

This chapter describes the status indicator lights (LEDs) on the SRM-L. Use the

LEDs to verify that the link module is operating after installation.

Figure

3-1 shows the LEDs on the SRM-L.

Figure 3-1. SRM-L LEDs

Note: We recommend that you issue the diags command to the associated

slot, using the Bay Networks Technician Interface, immediately after you

insert a link module. (Refer to Using Technician Interface Software.)

Otherwise, the link module FAIL LED will remain lit, indicating that

diagnostics have not run on the Intelligent Link Interface (ILI). However, even

if you do not issue the

diags command, the link module initializes and

becomes operational as long as the board functions properly and contains the

correct interface conﬁgurations.

VCC

SRML

JTAG

12V 2

12V 1

CONSOLE

SRM0001A

1 2 ... 22 23 24 25 26 27 28

Keine Kommentare

Avaya SRM Link Modules in BN Platforms Bedienungsanleitung Seite 27