Avaya Business Communications Manager - CallPilot Message Networking Bedienungsanleitung PDF herunterladen (Seite 24)

24 Chapter 3 Setting up AMIS

NN40090-301NN40090-301

To set up AMIS networking properties

1 Start Avaya CallPilot Manager.

2 Click the Networking heading.

3 Click the AMIS Networking Properties link.

The AMIS Networking Properties page appears.

4 In the Int’l Access Code box type the International Access code.

The code can have up to four digits. The International Access code for North America is 011.

5 In the Country Code box type the Country code.

The code can have up to four digits. The Country code for North America is 1.

6 In the Area Code box type the area code for your city, state or province.

The area code can have up to six digits.

7 In the Telephone Number box type the system phone number of your site.

This number can have up to 16 digits.

8 From the Outdial list box select an Outdial route:

select Line to select a specific outgoing line and type the line number in the Line/Pool # box

select Pool for CallPilot to select a line within a line pool and type the pool number in the

Line/Pool # box

select Route to outdial using routing codes.

For more information about routing codes, see the Avaya Business Communications Manager

Networking Configuration Guide if you use Avaya BCM.

9 Select the Enable Loopback check box if you want to enable the Loopback mailbox.

10 Select the Include System Name check box to include the system name in outgoing

messages.

11 Select the Include Sender Name check box to include the sender name in outgoing messages.

12 Click Voice to record a system name.

The System Spoken Name appears.

13 In the Connect to box, type the extension number or telephone number you are using to record

the greeting or prompt.

For a local extension, just type the extension number. For a telephone number that is not a

local extension, type the sequence of digits that dial the telephone number from the voice mail

system. For example, you might need to dial 9, the area code, and then the telephone number.

System name

You can record a system name. When you include the system name, the

recorded system name is added to all messages sent from your site. The

system name plays as part of the recorded message.

Sender name

The sender’s recorded name can be attached to each message sent from

your site. The sender’s name plays as part of the recorded message. The

default setting is disabled.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 69 70

Keine Kommentare

Avaya Business Communications Manager - CallPilot Message Networking Bedienungsanleitung Seite 24