Avaya CallPilot Message Networking Bedienungsanleitung PDF herunterladen (Seite 23)

Chapter 3 Setting up AMIS 23

CallPilot Message Networking Set Up and Operation Guide

7 In the Telephone Number box type the system phone number of your site.

This number can have up to 16 digits.

8 From the Outdial list box select an Outdial route:

select Line to select a specific outgoing line and type the line number in the Line/Pool # box

select Pool for CallPilot to select a line within a line pool and type the pool number in the

Line/Pool # box

select Route to outdial using routing codes.

For more information about routing codes, see the BCM Networking Configuration Guide if

you use BCM.

9 Select the Enable Loopback check box if you want to enable the Loopback mailbox.

10 Select the Include System Name check box to include the system name in outgoing

messages.

11 Select the Include Sender Name check box to include the sender name in outgoing messages.

12 Click Voice to record a system name.

The System Spoken Name appears.

13 In the Connect to box, type the extension number or telephone number you are using to record

the greeting or prompt.

For a local extension, just type the extension number. For a telephone number that is not a

local extension, type the sequence of digits that dial the telephone number from the voice mail

system. For example, you might need to dial 9, the area code, and then the telephone number.

14 Click Dial.

The telephone rings.

15 Pick up the handset. Do not use Handsfree. Click Record. After the tone, record the system

name.

16 After you finish recording, click Stop.

17 To listen to the recording, click Play, or to save the recording, click Save.

18 Click Close and replace your telephone handset.

The System Spoken Name window closes.

19 On the AMIS Networking Properties page, click Submit.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 77 78

Keine Kommentare

Avaya CallPilot Message Networking Bedienungsanleitung Seite 23