
Requirements Outside the ISP Network
303509-A Rev 00 8-15
Enabling L2TP on an Existing PPP Interface
To enable L2TP on an interface with PPP and IP already enabled, complete the
following tasks:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose a WAN connector.
The Edit Connector window opens.
2. Choose
Edit Circuit
. The Circuit Definition window opens.
3. Choose
Protocols
in the top left corner of
the window.
The Protocols menu opens.
4. Choose
Add/Delete
. The Select Protocols window opens.
5. Choose
L2TP
, then click on
OK
. The L2TP Configuration window opens.
6. Set the following parameters:
• RADIUS Primary Server IP Address
• RADIUS Primary Server Password
• RADIUS Client IP Address
7. Click on
OK
. The L2TP Tunneling Security window
opens.
8. Click on
OK
. The L2TP IP Interface List window opens,
followed by the L2TP IP Configuration
window.
9. Set the following parameters:
• L2TP IP Interface Address
• Subnet Mask
Site Manager displays a message
alerting you of the time delay to create
the L2TP tunnel circuits.
10.Click on
OK
. You return to the L2TP IP Interface List
window, which displays the IP interface
address and the subnet mask. A
message window opens that reads,
L2TP
Configuration is completed.
11.Click on
OK
.
12.Click on
Done
. You return to the Circuit Definition
window.
13.Choose
File
. The File menu opens.
14.Choose
Exit
. You return to the Configuration Manager
window.
Kommentare zu diesen Handbüchern