
Using the Second Ethernet Adapter Module
303126-C Rev 00
3
Completing Software Configuration
When you have successfully installed the Second Ethernet adapter module,
complete the following software configuration tasks using the instructions found
in your BayRS documentation.
For the latest information, be sure to review the Release Notes and Document
Change Notice for your version of BayRS software.
Interpreting LEDs
Table 2 describes the LEDs for the Second Ethernet adapter module, located to the
left of the connector (refer to Figure 1
).
These LEDs will blink on and off during diagnostic testing, but they will not stay
on to indicate data transfer until you configure the Ethernet interface.
Configuration Task Location of Instructions
Connect the Passport 2430 to the network. Installing and Operating the Passport 2430
Multiservice Access Switch
Modify the Passport 2430 configuration file
to add the second Ethernet adapter module.
One of the following:
• Configuring and Managing Routers with
Site Manager
• Using the Bay Command Console
(BCC)
Configure Ethernet line services. Configuring Ethernet, FDDI, and Token
Ring Services
Table 2. Second Ethernet Interface Adapter Module LEDs
LED Meaning
TX (Transmit) Lights when the Passport 2430 is transmitting data over the network.
RX (Receive) Lights when the Passport 2430 is receiving data from the network.
CL (Collision) Lights when the Passport 2430 detects a collision on the network.
Kommentare zu diesen Handbüchern