
3. If you are using DHCP, select Y
es.
If you are manually configuring the IP address, netmask, and gateway address,
select No.
4. If the DHCP option is configured, the IP address is automatically obtained.
5. Configure the TFTP IP address within the IP Deskphone Device Settings menu.
This can be the provisioning server as defined in the chapter
Configure the
provisioning server on page 33
.
6. Select the Apply&Reset context-sensitive soft key to save the settings and reset
the IP Deskphone.
The IP Deskphone downloads the software file. The display shows [FW]
reading….
If the download is successful, the display shows [FW] writing… and the blue LED
flashes.
After the software image is downloaded to the IP Deskphone, the display shows
[FW] finished..., the blue LED stops flashing, and the IP Deskphone resets.
If the upgrade is unsuccessful, see the chapter
Maintenance on page 281 in the
section “Download failures”.
Convert UNIStim software to SIP software on the
IP
Deskphone
The Avaya 1200 Series IP Deskphone can be ordered with UNIStim software installed or with
SIP software installed. If an IP Deskphone is installed with UNIStim software, it runs with SIP
software only if the software is converted from UNIStim to SIP. If the procedure to determine
the UNIStim version number is completed, and, if necessary, the procedure to upgrade the
UNIStim software is completed, then an IP Deskphone can be converted from UNIStim
software to SIP software.
Compare the version number to the minimum required UNIStim software version
(062AC5L).
UNIStim software version names contain numbers and letters. Use the last three characters
in a version to compare the version of UNIStim on an IP Deskphone with the minimum required
version for the upgrade.
The conversion must be performed using TFTP.
Convert UNIStim software to SIP software on the IP Deskphone
SIP Software for Avaya 1200 Series IP Deskphones-Administration November 2012 91
Kommentare zu diesen Handbüchern