Avaya a Power Module in the Passport 5430 Multiservice Access Switch Bedienungsanleitung PDF herunterladen (Seite 29)

Put on an antistatic wrist strap.

3. Disconnect the power cable from the power connector on the power

supply.

4. Using a flat-tip screwdriver, loosen the captive screw that fastens the

power supply to the chassis until the power supply disengages

(Figure 4).

5. Grasp the handle and using both hands, pull the power supply out of the

Passport 5430.

You can remove an operational power supply without affecting the

operation of the Passport 5430. When you remove a power supply, the

associated LED (PS1 or PS2) on the system processor module turns off,

and the Passport 5430 automatically redistributes the load to the

remaining power supply.

6. Grasping the handle, guide the replacement power supply into the slot

along the side guides and gently insert the supply (see Figure 4 on

page 11).

Caution:

Electrostatic discharge can damage hardware. You

must wear the antistatic wrist strap on your arm whenever you

handle printed circuit boards. Refer to the instructions

enclosed with your antistatic wrist strap to attach it.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Keine Kommentare

Avaya a Power Module in the Passport 5430 Multiservice Access Switch Bedienungsanleitung Seite 29