Avaya Configuring Data Compression Services Bedienungsanleitung PDF herunterladen (Seite 49)

Data Compression Parameters

114061 Rev. A A-5

WCP Circuit Interface Parameters

Use the following descriptions to set Bay Networks data compression.

Parameter: Fallback Compression Mode

Path: Conﬁguration Manager > Protocols > WCP > Lines

Default: Software CPC

Options: Software CPC

| Hardware PPC

Function: This parameter is for hardware compression only. Use it to indicate the

compression mode you want to use when no hardware compression contexts are

available.

Software CPC is a good choice for lower speed links, 64 Kb/s or less. It

generally affords a better compression ratio than does Hardware PPC.

Hardware PPC is a good choice for higher speed links, greater than 64 Kb/s. It

provides better throughput than does Software CPC.

Refer to Chapter 1 for explanations of continuous packet and packet-by-packet

compression modes.

Instructions: Select Software CPC or Hardware PPC.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.1.1.10

Parameter: Enable

Path: Conﬁguration Manager > Protocols > WCP > Interfaces

Default: Enable

Options: Enable

| Disable

Function: Enables or disables data compression on the line

Instructions: WCP automatically sets this parameter to Enable when you select WCP in the

Select Protocols window. If you want to temporarily disable WCP rather than

delete it from the platform, set this parameter to Disable. Reset it to Enable to

reenable WCP.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.2.1.2

1 2 ... 44 45 46 47 48 49 50 51 52 53 54

Keine Kommentare

Avaya Configuring Data Compression Services Bedienungsanleitung Seite 49