Avaya Hardware Compression Net Modules in ASN Platforms Bedienungsanleitung PDF herunterladen (Seite 24)

Installing Hardware Compression Net Modules in ASN Platforms

1-2

115374-A Rev. A

Removing the Component Tray

You need a Phillips screwdriver to complete this procedure.

To remove the component tray:

Power off the ASN.

Detach all cables from the ASN back panel.

Using a Phillips screwdriver, loosen the two captive screws that fasten the

tray to the chassis (Figure 1-1).

Pull the two captive screws and gently slide the tray out of the chassis

a few inches (Figur

e 1-1).

Hold the sides and bottom of the tray to support it, and then slide the

tray completely out of the chassis.

Try to keep the tray level as you slide it out.

Place the tray on a sturdy work surface.

Caution:

Do not touch any components or boards in the ASN until you have

attached an antistatic wrist strap. See the next section, “Attaching the

Antistatic Wrist Strap.”

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Keine Kommentare

Avaya Hardware Compression Net Modules in ASN Platforms Bedienungsanleitung Seite 24