Avaya Bogen Universal Paging Access Module Bedienungsanleitung PDF herunterladen (Seite 17)

[17]

Specific Instructions

Trunk Port Connections - Page Port

NOTE: Controls for VOX DELAY, PAGING TIME, MODE Switch S5 and AUX switches

S1, S2, S3, and S5 are not operable in this mode.

Procedure

1. Mount and ground the UPAM as described in the General Instructions (pages 7 - 8).

2. Set MODE switches S1 and S2 to OFF position for use with the 48-volt power

supply (or ON position if a 24-volt power supply is used).

3. Set MODE switches S3 and S4 for Pre-announce or Confirmation tone (as desired).

Note:

One of these modes must be selected for UPAM to operate correctly.

4. Set AUX switch S4 to ON position.

5. Plug the 8-conductor RJ45 modular cable (supplied) into the modular PAGE PORT

INPUT jack on the side of the UPAM. Do not insert RJ11 plugs.

NOTE: The modular jack on the side of the UPAM can usually be connected directly to the

telephone switch page port (via the 8-conductor modular cable included) when the

center 2 conductors of the page port jack supply a dry audio signal and the two

conductors flanking them provide a normally open contact closure.

6. Plug the other end of the 8-conductor modular cable into the modular page port

jack of the telephone switch.

NOTE: When connecting to a non-modular type of page port, cut off one end of the 8-

conductor modular cable, strip it, and connect the wires as shown in Figure 6. The

color arrangement of wires in the cable may not be standard among cables. Use the

plug detail diagram on page 18 to guide you in determining the correct wire colors

for connections to the page port.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Keine Kommentare

Avaya Bogen Universal Paging Access Module Bedienungsanleitung Seite 17