
Reviewed:
07/27/2010
BCM Test Lab Application Notes
©2010 Avaya Inc. All Rights Reserved.
11 of 38
BCM_Configuration_Guide_For
ATT.doc
NN10000-125
IP Trunks
Voice over IP (VoIP) trunks, are signaling channels that simulate how CO lines work.
However, VoIP trunks transmit data to the IP network over a LAN or IP network rather
than over physical lines. Once the VoIP trunks are set up, you can assign them to line
pools, and program their behavior in the same way you would PRI lines.
VoIP trunks use line numbers, which appear under
Configuration
Telephony
Lines
Active VoIP Lines
. To access VoIP lines, you need to enter software
keycodes. Each keycode supports a specific number of trunks. No entries appear in the
Enabled VoIP lines field until you complete the IP Trunks Settings field, which displays
when you click IP Trunks under
Configuration
Resources
Telephony
Resources
IP trunks
.
VoIP trunks should be configured to use a single line pool. Do not mix other trunk types
on the same line pool (e.g. analog, PRI, etc). The VoIP line pools are assigned to
routes, which, in turn, are configured with destination codes that route calls to the
BVoIP network.
Check under
Configuration
Telephony
Lines
Active VoIP Lines
to see if
trunks have been allocated. You should have a number of IP trunks displayed. The total
number of lines indicated corresponds to the number of IP trunks licensed by Avaya for
your BCM. See figure below.
offers two VoIP trunk license options: SIP Gateway Trunk License
and VoIP Trunk Gateway License. The SIP Gateway Trunk License enables SIP-only
trunks and the VoIP Trunk Gateway License enables SIP or H.323 trunks. Either type
of trunk licenses can be used for SIP signaling with AT&T IP Flexible Reach service.
Customers that desire a lower cost or have no requirements for H.323 should choose
the SIP Gateway Trunk License option.
Kommentare zu diesen Handbüchern