Avaya BCM50/450 Konfigurationsanleitung PDF herunterladen (Seite 4)

Reviewed:

07/27/2010

BCM Test Lab Application Notes

4 of 38

BCM_Configuration_Guide_For

ATT.doc

NN10000-125

Introduction

This document provides a configuration guide to assist Avaya BCM Release 5.0

administrators in connecting to AT&T IP Flexible Reach, IP Flexible Reach with Business

in a Box, and IP Toll-Free via SIP trunks

This document does not describe procedures to configure the BCM for

advanced functionality. For more information and procedures, please refer to

the Avaya technical documentation found on the Avaya website.

Pre-IP PBX Configuration Activity

This guide assumes that the administrator is knowledgeable in IP PBX

programming and operations.

An important tool that the administrators should have at their disposal prior to testing

their IP PBX with AT&T IP Flexible Reach is the Wireshark network protocol analyzer.

This software can be used to run and analyze traces on problem calls so the information

can be shared with equipment and network engineers. This free software can be

obtained at

http://www.wireshark.org/.

The customer may also use TCPDUMP which can be found on most UNIX and Linux

systems. The customer should have Wireshark or TCPDUMP loaded on a server that is

connected to a LAN switch or hub that can monitor both the signaling and media

packets on any calls between the customer PBX and the IP Flexible Reach managed

router.

Customer Questions

Section 4 of this guide provides screen shots and instructions for the configuration of

your IP PBX. Should you have questions regarding these instructions, please contact

Brian Stegemoller at +1 (972) 745-5139. When calling this number please have the

following information available:

BCM Release 5.0 introduces a built

in packet capture tool that can be used to capture

SIP signaling packets originating from and going to the BCM. These files can be

downloaded from the BCM to a computer and viewed. To view these files, Wireshark

(or similar) protocol analyzer is required on the destination computer.

1 2 3 4 5 6 7 8 9 ... 37 38

Keine Kommentare

Avaya BCM50/450 Konfigurationsanleitung Seite 4