Avaya Troubleshooting Routers Anleitung zur Fehlerbehebung Seite 203
- Seite / 266
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Using the Technician Interface to Configure and Run Packet Capture
117379-A Rev. A B-11
Allocating Memory for the Packet Capture File
You must allocate memory to store the Packet Capture file in order to capture
packets. By default, the Packet Capture file uses 0 bytes of memory.
Allocate memory to the Packet Capture file as follows:
1. Enter the following command to display the maximum number of
contiguous bytes available:
get wfKernelEntry.6.
<slot no.> <value>
6 represents the wfKernelMemoryMaxSegFree attribute.
2. Enter the following command to specify the size of the Packet Capture
file stored in memory:
set wfPktCaptureEntry.8.
<line_no.> <value>
;commit
• 8 represents the wfPktCaptureBufSize attribute.
•
<line_no.>
is the number displayed after you issued the get command in
“Cr
eating an Instance of Packet Capture” on page B-7.
To list the current line numbers associated with Packet Capture, enter the
command
list instances wfPktCaptureEntry.
•
<value>
is the number of KB of available contiguous memory, minus
200 KB. The value 1 represents 1024 bytes (1 KB) of memory allocated
for the Packet Capture file; the value 2 represents 2 KB.
To calculate the value, subtract 200 KB from the lowest number displayed
in response to the
get command that you entered in step 1; then, divide
this number by 1024. The result is the maximum value that Bay Networks
recommends that you enter.
The less memory you allocate to Packet Capture, the lower the chance that the
processor will reset because of a memory problem. However, you do need to
allocate enough memory to store the packets you want to capture.
Note: The allocation of memory varies. If the processors have memory
restrictions, enter this command every 15 seconds for 2 to 3 minutes and
record each response.
- Troubleshooting Routers 1
- Contents 5
- 117379-A Rev. A 10
- About This Guide 15
- Before You Begin 16
- Conventions 17
- Acronyms 18
- Bay Networks Customer Service 23
- How to Get Help 23
- Chapter 1 25
- Introduction 25
- Caution: 26
- Backing Up Your Files 27
- Preparing to Troubleshoot 28
- Filtering Event Messages 30
- 1-8 117379-A Rev. A 32
- 1-10 117379-A Rev. A 34
- 1-12 117379-A Rev. A 36
- • get 1.3.10.Pleasant.Easton 36
- <object> 37
- <attribute> 41
- Unknown Network or Network 44
- Unreachable 44
- <volume> 46
- Documenting Each Step 47
- 1-24 117379-A Rev. A 48
- Chapter 2 49
- 117379-A Rev. A 2-3 51
- Chapter 3 53
- Damaged Router 54
- Power Problem 54
- Blown Fuse 54
- LEDs Are Off 55
- Router Won’t Boot 55
- TRB0001A 57
- Checking the Boot PROMs 58
- Example 59
- Lost Password (BN Routers) 62
- No Space Left on Memory Card 63
- Memory or Buffer Problem 64
- 3-16 117379-A Rev. A 68
- TRB0002A 69
- TRB0005A 71
- Fault Message 72
- Chapter 4 73
- 4-2 117379-A Rev. A 74
- 117379-A Rev. A 4-3 75
- 117379-A Rev. A 4-5 77
- Chapter 5 79
- Interface Problems 80
- 5-4 117379-A Rev. A 82
- Troubleshooting ATM LANE 85
- 5-8 117379-A Rev. A 86
- 5-10 117379-A Rev. A 88
- 117379-A Rev. A 5-11 89
- 117379-A Rev. A 5-13 91
- 117379-A Rev. A 5-19 97
- <slot_no.> 100
- <slot> 101
- 117379-A Rev. A 5-25 103
- <connector_no.> 104
- <setting> 104
- <instance> 106
- <ENTITY> 107
- 5-30 117379-A Rev. A 108
- Chapter 6 109
- Troubleshooting AppleTalk 110
- 117379-A Rev. A 6-3 111
- Troubleshooting DLSw 112
- 117379-A Rev. A 6-5 113
- Troubleshooting IP 114
- <TELNET 116
- Ping Does Not Work 117
- <slot_no.> 119
- Network Unreachable Message 120
- Host Did Not Respond Message 120
- TRB0006A 121
- Troubleshooting RIP 122
- Troubleshooting OSPF 123
- Troubleshooting IPX 124
- 6-18 117379-A Rev. A 126
- <destination_address> 127
- <service_name> 128
- Troubleshooting OSI 129
- 117379-A Rev. A 6-25 133
- 6-26 117379-A Rev. A 134
- 117379-A Rev. A 6-29 137
- 117379-A Rev. A 6-31 139
- Chapter 7 141
- 117379-A Rev. A 7-3 143
- <community index> 146
- <IP address> 146
- (continued) 146
- 117379-A Rev. A 7-7 147
- <pathname> 149
- Chapter 8 151
- Getting Help 151
- Sending and Retrieving Files 153
- <filename> 154
- Appendix A 155
- Reading the Event Log 155
- System Startup 156
- A-4 117379-A Rev. A 158
- A-6 117379-A Rev. A 160
- A-8 117379-A Rev. A 162
- A-10 117379-A Rev. A 164
- A-12 117379-A Rev. A 166
- A-14 117379-A Rev. A 168
- A-16 117379-A Rev. A 170
- Dial-on-Demand Raise DTR Log 171
- A-18 117379-A Rev. A 172
- A-20 117379-A Rev. A 174
- Dial-on-Demand V.25bis 176
- A-24 117379-A Rev. A 178
- A-26 117379-A Rev. A 180
- A-28 117379-A Rev. A 182
- A-30 117379-A Rev. A 184
- A-32 117379-A Rev. A 186
- A-34 117379-A Rev. A 188
- A-36 117379-A Rev. A 190
- Appendix B 193
- Run Packet Capture 193
- Overview 194
- 117379-A Rev. A B-3 195
- Implementation Notes 196
- Getting Started 197
- B-6 117379-A Rev. A 198
- Creating an Instance for MCT1 199
- 10902101 200
- 117379-A Rev. A B-9 201
- Example 1 202
- Example 2 202
- <line_no.> 203
- <value> 203
- Starting Packet Capture 205
- Terminating Packet Capture 205
- Capture file: 208
- Example 4 209
- Using Optional Features 210
- Assigning Filters 213
- <attribute_no.> 214
- Specifying the Reference 216
- Specifying the Offset 217
- Configuration Examples 219
- Example 3 220
- Example 5 221
- Settings 222
- <IP_address> 225
- B-36 117379-A Rev. A 228
- Examples 229
- B-38 117379-A Rev. A 230
- 232
- 233
- 234
- <slot no.> 235
- 236
- B-46 117379-A Rev. A 238
- B-48 117379-A Rev. A 240
- B-50 117379-A Rev. A 242
- 243
- B-52 117379-A Rev. A 244
- Bisynchronous 245
- Frame Relay 245
- Passthru 246
- Standard PPP 246
- Bay Networks Proprietary PPP 246
- B-56 117379-A Rev. A 248
- B-58 117379-A Rev. A 250
- Appendix C 251
- Packet Configuration 251
- Using the Line Subcommand 252
- Packet Configuration 253
- C-4 117379-A Rev. A 254
- Using the Load Subcommand 255
- Using the Unload Subcommand 255
- 117379-A Rev. A Index-1 257
- 117379-A Rev. A Index-3 259
- 117379-A Rev. A Index-5 261
- Packet Size, B-12, B-44 262
- 117379-A Rev. A Index-7 263
- B-47, B-48 265
Verwandte Produkte und Handbücher für Vernetzung Avaya Troubleshooting Routers
Vernetzung Avaya BCM450 Bedienungsanleitung
(22 Seiten)
(22 Seiten)
Vernetzung Avaya BSGX4e Betriebsanweisung
(206 Seiten)
(206 Seiten)
Vernetzung Avaya Integrated Management Release 3.0 Standard Management Bedienungsanleitung
(52 Seiten)
(52 Seiten)
Vernetzung Avaya a WAN Adapter Module in a BayStack ARN Router (114204 Rev. A) Bedienungsanleitung
(34 Seiten)
(34 Seiten)
Vernetzung Avaya Business Communications Manager Telephone Anleitung zur Fehlerbehebung
(112 Seiten)
(112 Seiten)
Vernetzung Avaya Integrated Management Release 2.2 Network Management Console Betriebsanweisung
(154 Seiten)
(154 Seiten)
Vernetzung Avaya 1100-Series Bedienungsanleitung
(48 Seiten)
(48 Seiten)
Vernetzung Avaya BCM50 2.0 Betriebsanweisung
(26 Seiten)
(26 Seiten)
Vernetzung Avaya 0604DAX Hinweis
(20 Seiten)
(20 Seiten)
Vernetzung Avaya R5.0: Konfigurationsanleitung
(20 Seiten)
(20 Seiten)
Minka Lavery 1424-281 manuales
Manuales del propietario y guías del usuario para No Minka Lavery 1424-281.
Ofrecemos 1 manuales en pdf Minka Lavery 1424-281 para descargar gratis por tipos de documentos: Manual de instrucciones
Kommentare zu diesen Handbüchern