Avaya Configuring Data Compression Services Bedienungsanleitung PDF herunterladen (Seite 35)

3-1

Chapter 3

Enabling Data Compression Services

This chapter describes how to enable data compression services. It assumes you

have read Conﬁguring Routers and that you have

1. Opened a conﬁguration ﬁle

2. Speciﬁed hardware if this is a local mode conﬁguration ﬁle

3. Selected the link or net module connector on which you are enabling data

compression

4. Selected Frame Relay, PPP, or X.25 from the WAN Protocols window

When you enable data compression, you do not have to conﬁgure any data

compression parameters. The Conﬁguration Manager supplies default values for

all data compression parameters. If you want to edit these default values, refer to

Chapter 4.

Enabling Data Compression for PPP and Frame Relay

You enable data compression from the Select Protocols window (Figure 3-1) that

appears after you select Frame Relay or PPP from the WAN Protocols window.

Enabling Data Compression for X.25

To enable data compression for X.25, select Protocols➔Add/Delete from the X.25

Service Conﬁguration Window after you have Added a Service record (see

Conﬁguring X.25 Services). The Select Protocols window appears.

Note: If you want to use hardware-based compression, you must select an

Octal Sync Link Module that has a hardware compression daughterboard,

either AG2104037 or AG2104038.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Keine Kommentare

Avaya Configuring Data Compression Services Bedienungsanleitung Seite 35