Avaya Configuring Routers Bedienungsanleitung Seite 51

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 108
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 50
Adding Network Interfaces
114080 Rev. A 2-5
Figure 2-2. WAN Protocols Window
3. Select the WAN protocol you want to enable on the circuit and click on
OK.
When you select a WAN protocol, note that
-- Selecting Frame Relay, PPP, or SMDS automatically enables protocol
prioritization. For information on protocol prioritization, refer to
Configuring Traffic Filters and Protocol Prioritization.
-- Once you select Standard, you cannot change the WAN protocol on this
circuit to any of the other protocols. If you later want to enable any other
protocol on this circuit, you must delete the circuit and start over. For
instructions on deleting a circuit from the router, refer to Chapter 4.
When you enable a WAN protocol on the circuit, the synchronous line parameters
are automatically set, as
Table 2-2 shows.
Seitenansicht 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare