
Configuring Routers
2-6 114080 Rev. A
See Configuring Line Services for more information.
-- If you are configuring an AN or ASN router, an ASYNC option appears
in the WAN Protocols window
(Figure 2-2). See Configuring Line
Services for more information on editing the ASYNC parameters.
If you selected the Standard, PassThru, PPP, or Frame Relay WAN protocol, the
Configuration Manager displays the Select Protocols window. Go directly to the
“Enabling Bridging/Routing Services” section for instructions.
If you selected another WAN protocol, you must specify a few additional
parameters before proceeding to the “Enabling Bridging/Routing Services”
section. Depending on the WAN protocol you selected (ATM DXI, ATM FRE2,
SMDS, SDLC, or X.25), you must refer to one of the following manuals for
instructions on enabling the protocol:
• If you selected ATM DXI or ATM FRE2, refer to Configuring ATM DXI
Services or Configuring ATM Services, respectively.
• If you selected SMDS, refer to Configuring SMDS.
• If you selected SDLC, refer to Configuring SDLC Services.
• If you selected X.25, refer to Configuring X.25 Services.
Enabling Bridging/Routing Services
Once a circuit is configured, the Configuration Manager displays the Select
Protocols window
(Figure 2-3) from which you select the bridging/routing
protocols you want to run over that circuit.
Table 2-2. Synchronous Line Parameters
Parameter Setting
BOLF Disable
Promiscuous Enable
Service Transparent
WAN Protocol Chosen WAN protocol
Kommentare zu diesen Handbüchern