Avaya IP Telephony Konfigurationsanleitung Seite 102
- Seite / 222
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
102 Chapter 6 Setting up VoIP trunks for outgoing calls
P0609327 02
Figure 29 Internal call from Meridian 1 tandems to remote PSTN line
Since the VoIP trunks are configured into line pools, you can assign line pool codes to users who
have been assigned access to the VoIP trunks. However, if you intend to set up your system to use
fallback, so that calls can go out over land lines if the VoIP trunks are not available, you must use
routes and destination codes to access the VoIP trunk line pools.
Setting up remote gateways and end points
This section explains how to set up your system to place calls through VoIP trunks. The system at
the other end of the call must be set up to receive VoIP calls. For information about this, refer to
“Outgoing call configuration” on page 107.
Programming for connecting Business Communications Managers together using PRI SL-1 lines
and MCDN protocol is described in detail in the Programming Operations Guide, Private
Networking section. VoIP trunks are configured in the same way, with the addition of gateway
programming required for IP trunks, which is explained in the sections following. Local gateway
settings are described in “Setting up the local gateway” on page 91.
For detail about outgoing call configuration view the information under the following headings:
• “Configuring a remote gateway (H.323 trunks)”
• “Configuring remote endpoints (SIP trunks)” on page 106
Business Communications
Manager
VoIP trunk with
MCDN
Calgary
Ottawa
Node B
Node A
Node C
Meridian 1
Headoffice
VoIP trunk with
MCDN
- Business Communications 1
- Manager 3.6 1
- IP Telephony Configuration 1
- Trademarks 2
- Contents 3
- Chapter 3 4
- Chapter 4 4
- Chapter 5 5
- 10 Contents 10
- P0609327 02 10
- Before you begin 15
- Symbols used in this guide 15
- Text conventions 16
- Acronyms 17
- Related publications 18
- How to get help 19
- 20 Preface 20
- Chapter 1 21
- Introduction 21
- IP telephones and VoIP trunks 22
- Figure 1 Network diagram 24
- Telephones 25
- Gatekeepers on the network 25
- IP network 26
- Key IP telephony concepts 27
- Jitter Buffer 28
- QoS routing 29
- Chapter 2 31
- Prerequisites checklist 31
- Network devices 32
- Network assessment 33
- Resource assessment 33
- Keycodes 34
- Option Description 35
- VoIP trunks 39
- IP telephone records 40
- Installing IP telephones 41
- Choosing a codec 45
- Choosing a Jitter Buffer 46
- Before installing 46
- Using a 3-port switch 46
- Display buttons 48
- Troubleshooting IP telephones 51
- Operation issues 52
- Configuring DHCP 53
- IP telephony DHCP notes 54
- Checking IP server status 56
- Figure 7 IP Terminal status 57
- Notes about Hot Desking 62
- Customizing feature labels 63
- Moving IP telephones 69
- Figure 16 i2050 Switch type 72
- Handset and call functions 74
- Configuring NetVision records 75
- Assigning general settings 76
- Changing a handset Name 82
- Deregistering a telephone 83
- Configuring local VoIP trunks 85
- Published IP address 86
- Counting IP trunks 87
- Configuring media parameters 89
- Setting up the local gateway 91
- How to use target lines 98
- Configuring target lines 99
- Chapter 6 101
- Field Value Description 104
- 6 Click the Save button 105
- Outgoing call configuration 107
- H.323 trunks 108
- SIP trunks 108
- Keycodes: 2 108
- PSTN call to remote node 109
- Call process 110
- Describing a fallback network 113
- Adding routes for fallback 114
- Figure 35 Route XXX screen 115
- Figure 36 VoIP schedule 117
- How fallback routing works 120
- Settings for 124
- Santa Clara 124
- Connecting an i200X telephone 125
- PSTN fallback metrics 126
- Quality of Service Monitor 127
- Updating the QoS monitor data 128
- Chapter 7 129
- 3 Enter the port settings 130
- Modifying PortRanges 131
- Using a gatekeeper 133
- 8 Click Submit 140
- Gatekeeper call scenarios 141
- Faxing over VoIP lines 142
- Chapter 8 147
- WarehouseHead Office 148
- Appendix A 153
- Efficient Networking 153
- Network engineering 154
- LAN engineering examples 157
- WAN engineering 158
- Setting Non-linear processing 159
- Enough link capacity 161
- Further network analysis 162
- Components of delay 163
- Reduce link delay 163
- Reducing hop count 164
- Adjust the jitter buffer size 164
- Reduce packet errors 164
- Routing issues 165
- Appendix B 167
- Silence compression 167
- Time -> 169
- Bandwidth -> 169
- Channel/Link Max 169
- Comfort noise 172
- Appendix C 173
- Network performance utilities 173
- Appendix D 175
- Interoperability 175
- Speech path setup methods 176
- Media path redirection 177
- Gatekeeper 177
- No feedback busy station 178
- Interoperability 179 179
- 180 Interoperability 180
- Using VLAN on the network 181
- 182 Interoperability 182
- Symbol NetVision telephones 183
- 184 Interoperability 184
- Interoperability 185 185
- 186 Interoperability 186
- Interoperability 187 187
- 188 Interoperability 188
- Interoperability 189 189
- 190 Interoperability 190
- Appendix E 191
- Quality of Service 191
- 192 Quality of Service 192
- Measuring Intranet QoS 193
- Recording routes 194
- Adjusting Ping measurements 195
- Measurement procedure 196
- Quality of Service 197 197
- Traffic mix 198
- TCP traffic behavior 199
- Network Quality of Service 200
- Quality of Service parameters 201
- Fallback to PSTN 201
- 202 Quality of Service 202
- Glossary 203
- 204 Glossary 204
- Glossary 205 205
- 206 Glossary 206
- Glossary 207 207
- 208 Glossary 208
- Glossary 209 209
- 210 Glossary 210
- 222 Index 222
Verwandte Produkte und Handbücher für Software-Handbücher Avaya IP Telephony
(190 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.067 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern