Avaya Configuring Traffic Filters and Protocol Prioritization Bedienungsanleitung PDF herunterladen (Seite 77)

Outbound Traffic Filter Criteria and Actions

308645-14.00 Rev 00

4-11

Prioritizing Actions

You can apply the following actions to outbound traffic filters for WAN protocols:

• High

Directs packets that match the filter criteria and ranges to the High queue

•Low

Directs packets that match the filter criteria and ranges to the Low queue

• Length

Uses the length of packets to determine the priority queue

Outbound traffic filters with a prioritizing action are called priority filters.

See Chapter 2 for detailed information about protocol prioritization.

Dial Service Actions

You can apply the following actions to outbound traffic filters for interfaces

configured as dial-up lines:

•No Call

Packets that match the filter criteria and ranges are dropped and do not initiate

a dial connection. (By default, packets transmitted on dial-on-demand lines

always trigger the router to establish a connection.)

• No Reset

Packets that match the filter criteria and ranges are processed but do not reset

the inactivity timer.

Note:

You can apply prioritizing actions only to MCE1, MCT1, and

synchronous interfaces. The Configuration Manager does not support priority

filters on the LAN interfaces.

Note:

Although No Call and No Reset are available when creating any

outbound traffic filter, these actions are useful only on dial-up interfaces such

as synchronous modem lines or MCT1 interfaces configured with ISDN PRI.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 183 184

Keine Kommentare

Avaya Configuring Traffic Filters and Protocol Prioritization Bedienungsanleitung Seite 77