Avaya FireWall-1 Bedienungsanleitung PDF herunterladen (Seite 64)

Configuring BaySecure FireWall-1

B-2

117384-D Rev 00

To reenable firewall on each IP interface, use the BCC to navigate to the

prompt for the slot/connector on which you have configured the IP interface

(for example,

box; eth 2/2). Then enter:

ip address

<ip_address>

mask

<address_mask>

ip_address

is the IP address you have assigned to the interface.

address_mask

is the mask associated with the IP address.

The prompt for the IP interface appears.

For example, the following command invokes the prompt for IP interface

2.2.2.2/255.0.0.0 (which has been configured on Ethernet slot 2, connector 2):

ethernet/2/2# ip address 2.2.2.2 mask 255.0.0.0

ip/2.2.2.2/255.0.0.0#

At the prompt for the IP interface, enter the following command to reenable

firewall:

firewall

The firewall prompt appears. For example, the following command reenables

firewall on the IP interface 2.2.2.2/255.0.0.0:

ip/2.2.2.2/255.0.0.0# firewall

firewall/2.2.2.2#

If you want to use FireWall-1 on more than 32 circuits, set the policy

index number for each IP interface.

The policy index number is a value that lets multiple IP interfaces share the

same instance of FireWall-1. You can have up to 32 instances of FireWall-1 on

the router, with many IP interfaces making up each FireWall-1 instance. All

interfaces that make up an instance grouping must share the same security

policy.

By default, the policy index for each interface is the same as the circuit

number. If you are using FireWall-1 on 32 or fewer circuits, you do not need

to configure the policy index number.

1 2 ... 59 60 61 62 63 64 65 66 67 68

Keine Kommentare

Avaya FireWall-1 Bedienungsanleitung Seite 64