Avaya Using Technician Interface Software Bedienungsanleitung Seite 248

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 382
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 247
Using Technician Interface Software
8-86 117381-A Rev. A
Obtaining IPv6 Route and Node Information
The ip6 routes command displays IPv6 routes using the various subcommand
options mentioned in T
able 8-12.
Table 8-12. Options for ip6 routes Command
Option Description
<address>
Retrieves IPv6 addresses (prefixes) that match the address
(prefix) entry
<address/prefix length>
Retrieves a range of IPv6 addresses (prefixes) that match your
entry. Specify all or part of an IPv6 address and a prefix length
from 1 to 128 bits.
-i
<ifindex>
Retrieves all routes that point out the interface index number
you specify
-p
<protocol>
Retrieves data for all routes sourced by the protocol you specify.
Protocol options are as follows:
DIR - directly attached networks
ST - static network routes
RIP - RIPv6 routes
ND - neighbor discovery routes
IDRP - IDRP routes
IF - local interface routes
SN - static adjacent node addresses
DN - dynamically learned adjacent node addresses
SYS - routes installed by the IPv6 kernel
-n Retrieves data for all network routes
-h Retrieves data for all local node (host) routes
-l Displays data in long format (that is, provides additional route
information including the type of route interface, the next hop
IPv6 address, and when the route was last updated)
Note: Dynamically learned adjacent node addresses appear only when you
apply the
-pDN option.
Seitenansicht 247
1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 381 382

Kommentare zu diesen Handbüchern

Keine Kommentare