
Using Technician Interface Software
C-24 117381-A Rev. A
Disabling or Reenabling Syslog Hosts or Filters
You can disable or reenable host or filter entries already defined in your Syslog
configuration as follows:
1. Disable or reenable message forwarding to a Syslog host, as follows:
• Disable a Syslog host anytime after adding it to the router configuration
by entering the following command line:
$: set
wfSyslogHostEntry.wfSyslogHostDisable.
<wfSyslogHostDest>
2;commit
Disabling a host
• Transitions the operational state of that Syslog host entry and its
corresponding filters to INACTIVE
• Stops Syslog from forwarding event messages to the host
• Reenable message forwarding to a specific Syslog host by entering the
following command line:
$: set
wfSyslogHostEntry.wfSyslogHostDisable.
<wfSyslogHostDest>
1;commit
Reenabling a host
• Transitions the operational state of that Syslog host entry and its
corresponding filters to ACTIVE
• Allows Syslog to resume forwarding event messages to the host
2. Disable or reenable an entity filter for a specific Syslog host, as follows:
• Disable an entity filter anytime after adding it to the router configuration
by entering the following command line:
$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.
<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.
<wfSyslogEntFltrIndex>
2;commit
Disabling a filter
-- Transitions the operational state of that filter
(wfSyslogEntrFltrOperState) to INACTIVE
-- Stops Syslog from forwarding event messages through that filter
Kommentare zu diesen Handbüchern