Avaya 6424D+M Bedienungsanleitung PDF herunterladen (Seite 16)

Making a Data Call From a Terminal or PC Using AT Local

Mode Commands

The Local Mode data option must be set for AT Local Mode. See the earlier section, "Setting

Options To Make a Data Call".

1 Turn on your data terminal or PC.

If you are using a PC, make certain your communications software is configured

properly at the speed and parity you want to use.

2 Type

atd

and the telephone number. For example, type

atd 1234567

3 Press

RETURN

. The ADM’s response will be similar to what is shown below.

CONNECT 9600

Supplementary circuit switched data features may require the entry of additional dialing

information prior to the receipt of the CONNECT message. To facilitate the use of these

features, the ADM allows you to enter additional ATD commands before the CONNECT

message Depending upon the network’s response to the initial dialed digits, you may or may

not receive a CONTINUE message after the initial dial command.

Conventional Hayes compatible applications abort data call attempts which have not yet

connected upon receipt of any character. One consequence of allowing secondary dial

commands is that in order to terminate (abort) such a call attempt, you must issue an ATH

(hangup) command rather than typing any character.

You are now ready to communicate with the far end. Enter data to be transmitted.

4 To end a data call, do one of the following:

press the

DATA/SEND/OFF

button

rapidly type the Attention sequence:

+++

(see the description of the Attention option in

Chapter 4, Data Options and Profiles).

The OK prompt is displayed.

Type

ath

to end the call

2-8 Chapter 2

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 73 74

Keine Kommentare

Avaya 6424D+M Bedienungsanleitung Seite 16