Avaya B5800 Bedienungsanleitung PDF herunterladen (Seite 104)

9. Click OK.

10. Select File > Save Configuration.

Disabling unused trunks

About this task

Each B5800 Branch Gateway trunk card provides a fixed number of trunk ports with digital

trunk ports supporting a fixed number of digital channels. By default th B5800 Branch Gateway

configuration will have settings for all the possible trunks and channels.

In cases where the number of trunks or trunk channels in use is lower than the number

supported by the trunk card, the unused trunks and channel must be disabled.

Important:

Failure to do this will cause problems with outgoing calls.

Procedure

1. Start Manager and connect to the B5800 Branch Gateway system.

2. In the left navigation pane, click Line.

3. For each line, set those lines or channels that are not connected or not being used

as Out of Service.

The location of the relevant setting varies for each trunk type.

4. For Analog Trunks, set the Trunk Type to Out of Service.

5. For BRI, E1 PRI, S0 and QSIG Trunks, set the channels quantities to match the

actual subscribed channels.

6. For T1, T1 PRI and E1R2 Trunks, select the Channels tab. Then do the following:

a) Select those channels that are not used and click Edit.

• For T1 set the Type to Out of Service

• For T1 PRI set the Admin field to Out of Service.

• For E1R2 trunks set the Line Signalling Type to Out of Service.

7. Select File > Save Configuration.

Initial configuration for a Centralized Branch

104 Implementing the Avaya B5800 Branch Gateway November 2011

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 341 342

Keine Kommentare

Avaya B5800 Bedienungsanleitung Seite 104