Avaya Configuring MPLS Services Bedienungsanleitung PDF herunterladen (Seite 75)

Site Manager Parameters

305754-A Rev 00

A-5

Parameter: Hold Time

Path: Configuration Manager > Circuits > Edit Circuits > Edit > MPLS > LDP

Default: 40

Options: 1 to 240

Function: S

pecifies the number of seconds that LDP can wait without receiving a

keepalive packet from its peer entity before considering the LDP session down.

Instructions: A

ccept the default hold time, 40 seconds, or specify a hold time from 1 to 240

seconds.

MIB Object ID: 1.3.6.1.4.1.18.3.5.9.15.1.1.11

Parameter: Protocol

Path: Configuration Manager > Circuits > Edit Circuits > Edit > MPLS > LDP

Default: OSPF

Options: OSPF

RIP

OTHER

Function: S

pecifies the protocol that LDP uses to configure routes or allows LDP to use

both a protocol and IP static routes.

Instructions:

Accept the default, OSPF, for OSPF routing. Specify RIP to use the Routing

Information Protocol. By using either the OSPF or RIP setting, LDP does not

use any of the IP static routes in the route table.

To use static routes based on the entries in the forwarding information base

(FIB) along with OSPF, specify HYBRIDOSPF. To use static routes along with

RIP, specify HYBRIDRIP.

MIB Object ID: 1.3.6.1.4.1.18.3.5.9.15.1.1.12

Note:

The routes configuration mode takes precedence over the protocol that

you set (see “

Routes Configuration Mode” on page A-4). This means that

when you set the routes configuration mode to Manual, LDP disregards the

protocol setting.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 91 92

Keine Kommentare

Avaya Configuring MPLS Services Bedienungsanleitung Seite 75