
Customizing PPP
114068 Rev. A 3-5
Enabling Bridging
Before you can enable a particular type of encapsulated bridged traffic, you must
enable bridging on the interface. You do this by default if you enabled bridging
when you initially set up the PPP interface, but you can disable or re-enable it
here. To stop traffic from being bridged over this interface, set this parameter to
Disable.
This parameter enables or disables the network control protocol for the bridge. It
does not enable or disable bridging services for the interface. However, disabling
the network control protocol for the bridge stops traffic from being bridged over
this interface.
Enabling Ethernet Bridging
If you want PPP to accept and forward Ethernet-encapsulated bridged traffic, set
this parameter to Enable (the default).
Set this parameter to Disable if you do not want PPP to accept and forward
Ethernet encapsulated frames.
Enabling FDDI Bridging
If you want PPP to accept and forward FDDI encapsulated bridged traffic, set this
parameter to Enable (the default).
Set this parameter to Disable if you do not want PPP to accept and forward FDDI
encapsulated frames.
Enabling Token Ring Bridging
If you want PPP to accept and forward Token Ring encapsulated bridged traffic,
set this parameter to Enable (the default).
Site Manager: Bridge Enable parameter: page A-5
Site Manager: Bridge Ethernet parameter: page A-9
Site Manager: Bridge FDDI parameter: page A-10
Kommentare zu diesen Handbüchern