
Configuring PPP Services
3-20 114068 Rev. A
The peer whose timer is enabled generates one LQR packet for each interval
specified in the LQR Reporting Period parameter. The peer whose timer is
disabled verifies that the other peer did, in fact, send an LQR. If three successive
LQRs are not received, the receiving peer disables the connection.
Accept the default, Enable, if you want the remote peer router to maintain an LQR
timer for the interface. Reset this parameter to Disable if you do not want the peer
to maintain the LQR timer for the interface.
Specifying the Link Quality Reporting Period
The LQR Reporting Period parameter specifies the maximum number of seconds
between the transmission of LQR packets.
Enter a number representing the interval between the transmission of LQR
packets. The value of this parameter can be from 1 through 120 seconds. The
default value is 3 seconds.
Specifying the Inbound Link Quality
The Inbound Link Quality parameter specifies the minimum acceptable success
rate (percentage) of packets the peer router transmits and this router receives on
this interface over the last 5 LQR reporting periods.
If the percentage drops below the inbound link quality you specify, the router
brings down the link until the percentage increases to an acceptable level.
The default value for this parameter is 90 (percent). You can specify values in the
range 1 through 100 (percent).
Site Manager: Peer Link Quality Report Timer parameter: page A-21
Site Manager: LQR Reporting Period parameter: page A-21
Site Manager: Inbound Link Quality parameter: page A-22
Kommentare zu diesen Handbüchern