Avaya Configuring SMDS Bedienungsanleitung PDF herunterladen (Seite 37)

Implementation Notes

114069 Rev. A 2-7

To conﬁgure multinet, follow these steps:

1. In your SMDS conﬁguration parameters, enter addresses in the Group

Address, ARP Address, and Individual Address parameters described in

Chapter

3 of this book.

2. In your IP interface conﬁguration, enter the same addresses that you

entered in the SMDS parameters in the previous step.

The equivalent IP parameters are SMDS Group Address, SMDS ARP Req

Address, and MAC address. Refer to Conﬁguring IP Services for information

about these IP parameters.

3. Add a new IP interface with a unique IP address, which includes a

network/subnet and host address.

4. Enter the same Group Address, ARP Address, and Individual Address

that you entered in Step 2 for this new IP interface.

Multigroup

Multigroup is a feature of the Internet Protocol (IP) that enables you to conﬁgure

multiple SMDS group addresses on the same SNI, which is the access interface to

the SMDS network. The router implements multigroup according to RFC 1209.

For information about IP, refer to Conﬁguring IP Services.

Figure

2-6 shows a multigroup conﬁguration.

Figure 2-6. Multigrouping SMDS and IP Addresses

Once you conﬁgure an SMDS group address, you can then assign this group

address to at least one IP subnetwork. An IP address identiﬁes the subnetwork.

Note: You may also conﬁgure many individual addresses for an SMDS group

address, but ensure that each individual address within a group is unique.

Group Address Individual Address lP Address

SMS0009A

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Keine Kommentare

Avaya Configuring SMDS Bedienungsanleitung Seite 37