
Configuring Bridging Services
1-24 117351-A Rev. A
Parameter: Enable
Default: If you added bridging using either the Quick-Start procedure or the
configuring-circuits procedure, this parameter defaults to Enable. If you
previously used this parameter to disable bridging on this circuit, the
parameter defaults to Disable.
Options: Enable
| Disable
Function: Toggles bridging on and off for this circuit only.
Instructions: This parameter does not allow you to add bridging to this circuit. To add
the bridging protocol to this circuit, you must use the Configuration
Manager (see Configuring and Managing Routers with Site Manager).
Set this parameter to either Enable or Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.3.1.2
Parameter: Translational Bridge Enable
Default: Disable
Options: Enable
| Disable
Function: Specifies whether this transparent bridge interface participates in a
transparent-to-source-routing translation-bridged network.
Instructions: Set this parameter to Enable or Disable, depending on your interface.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.3.1.9
Editing Spanning Tree Global Parameters
To edit the spanning
tree global parameters:
1. Select Protocols > Bridge > Spanning Tree > Global from the
Configuration Manager window (see F
igure 1-14 on page 1-19).
The Edit Spanning Tree Global Parameters window appears (F
igure 1-17).
Kommentare zu diesen Handbüchern