Avaya Configuring Bridging Services Bedienungsanleitung Seite 81

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 208
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 80
Using Source Routing Bridge Services
117351-A Rev. A 2-25
Specify a ring ID for the backbone IP network to which the source routing
interface connects. You enter the IP network’s ring ID using the Conn. IP
NTWK Ring Number parameter for each source routing bridge. (See “Editing
Source Routing Global Parameters” on pa
ge 2-34 for details on accessing this
parameter.) Specify the same IP network ring ID for each Bay Networks
source routing bridge that connects to the network.
Enable IP encapsulation on the source routing bridges that connect to the IP
backbone. You reset the IP Encapsulation parameter to Enable for each source
routing bridge. (See “Editing Sour
ce Routing Global Parameters” on
pa
ge 2-34 later in this chapter for details on accessing this parameter.)
Specify the IP Explorer list for each source routing interface that connects to
the IP backbone.
The IP Explorer list defines the IP addresses that will receive explorer frames
from the bridge. These IP addresses are assigned to the token rings of remote
users. (See “Adding or Deleting an IP Address on the IP Explorer Address
List” on page 2-48 for details on the IP Explorer list.)
Create directed explorer filters to reduce excess broadcast traffic on the
network. (See Configuring Traffic Filters and Protocol Prioritization for
details on filters.)
Enabling Source Routing Services
This section describes how to enable the following services on an interface:
Source routing
Source routing spanning tree
It assumes you have read Configuring and Managing Routers with Site Manager
and that you have
1. Opened a configuration file
2. Specified router hardware if this is a local-mode configuration file
3. Selected the link- or net-module connector on which you are enabling
source routing, or configured a WAN circuit if this connector requires
one
Seitenansicht 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 207 208

Kommentare zu diesen Handbüchern

Keine Kommentare