Avaya IP Telephony Konfigurationsanleitung PDF herunterladen (Seite 41)

Chapter 3 Installing IP telephones 41

IP Telephony Configuration Guide

Preparing your system for IP telephone registration

When you install an IP telephone on a Business Communications Manager, you must activate

terminal registration on the Business Communications Manager. If this is your first installation,

you need to set the general parameters for IP registration.

1 In Unified Manager, open Services, IP Telephony, IP Terminals and Nortel IP Terminals.

2 Select the General tab.

The General screen appears.

Figure 5 Set registration properties

Note: For the simplest installation possible, set telephone Registration and

Auto Assign DNs to ON, and leave Password blank. IP telephones installed on the

system LAN will connect and boot-up without manual registration.

Security Note: Turn Registration and Auto Assign DNs off once the telephone(s) are

registered. Nortel cautions that leaving your IP registration open and unprotected by a

password may pose a security risk.

Caution: DN auto assign: Call Center DNs (CDNs) and IP telephones share a common

DN database. If you use auto assign to assign DNs to your IP telephones, the system can

inadvertently assign an IP telephone to a DN within the CDN range. CDNs do not register

to the system, so the system has no way of knowing that the DN is already assigned. If this

happens, you can rename the IP DN to a DN outside the CDN range and reenter the CDN

information.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 211 212

Keine Kommentare

Avaya IP Telephony Konfigurationsanleitung Seite 41