Avaya Configuring BOOTP Services Bedienungsanleitung PDF herunterladen (Seite 24)

Configuring SNMP, BootP, and DHCP Services

1-4

308644-15.1 Rev 00

Using Site Manager

Before you can select a protocol to run on the router, you must configure a circuit

that the protocol can use as an interface to an attached network. For information

and instructions, see Configuring WAN Line Services and Configuring Ethernet,

FDDI, and Token Ring Services.

When you have successfully configured the circuit, the Select Protocols window

opens. Proceed as follows:

Site Manager Procedure

You do this System responds

1. In the Select Protocols window, select

Then click on

If you plan to add BootP or DHCP

services, you can also select BootP.

The IP Configuration window opens.

2. Set the following parameters:

•

IP Address

•

Subnet Mask

•

Transmit Bcast Addr

•

UnNumbered Assoc Address

Click on

Help

or see

Configuring IP, ARP,

RARP, RIP, and OSPF Services

for

parameter descriptions.

3. Click on

. Site Manager displays a window asking

whether you want to enable TFTP on the

router.

4. Click on

Yes

to enable TFTP. Otherwise,

click on

You return to the Configuration Manager

window.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 195 196

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya Configuring BOOTP Services Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya Configuring BOOTP Services