Avaya Configuring DLSw Services Bedienungsanleitung PDF herunterladen (Seite 179)

Editing DLSw Parameters

303523-A Rev. 00

5-43

Type the 0x prefix and then enter a hexadecimal value for the SAP

parameter.

Valid SAP addresses include even values 00, 04 to EC, and F0.

Click on OK.

This saves your entry to the router configuration file. The DLSw SAP

Configuration window reappears (refer to Figure 5-16

) with the new entry

added to the list of existing DLSw SAPs.

Repeat Steps 1 through 3 for each SAP that you want to add.

Click on Done.

The Configuration Manager window reappears.

Following is a description of the SAP parameter.

Parameter: SAP

Default: None

Options: A valid even SAP address (00 to F0) in hexadecimal format

Function: Specifies the destination SAP address associated with a communication

subsystem on a remote device (for example, on a PC or host).

Instructions: Begin the address with 0x and type the SAP address associated with a

specific communication subsystem. For example, the SAP associated with

NetBIOS is 0xF0.

MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.4.1.2

Editing a DLSw SAP Table Entry

You can edit only the SAP Window (flow control) parameter associated with an

existing DLSw SAP Table entry.

Note:

After you add an entry to the DLSw SAP Table, Site Manager disallows

any attempt to edit the SAP address associated with that entry. To change the

address of an existing DLSw SAP, you must delete the entry in the DLSw SAP

Configuration window, and then add a new SAP with the new address. Refer to

the preceding section, “Adding a DLSw SAP Table Entry,” for information

about how to add a new DLSw SAP.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 291 292

Keine Kommentare

Avaya Configuring DLSw Services Bedienungsanleitung Seite 179