Avaya Upgrading Routers from Version 5 to Version 10.0 Bedienungsanleitung PDF herunterladen (Seite 14)

Upgrading Routers from Version 5 to Version 10.0

1-2

Router Upgrade Prerequisites

Do not begin this router software upgrade process until you verify that the router

meets the prerequisites described in this chapter for

• Minimum hardware

• Contiguous free space on a Flash volume

• Boot PROM version

Minimum Hardware Requirements

Before you upgrade an AFN, ALN, FN, LN, or CN router to Router Software

Version 10.0, perform the following steps to ensure that the router meets all

minimum hardware conﬁguration and revision level requirements:

Ensure that the VME router you want to upgrade contains a Flash

memory controller and a Flash card.

To determine whether your VME router contains a Flash memory controller,

look at Slot 1 in the router module. The Flash memory controller resides in

this slot.

Version 10.0 router software runs on Flash media only.

Complete any planned (optional) upgrade from 2-MB Flash to 4-MB

Flash support on a router.

This procedure includes a Boot PROM upgrade for a Flash controller module.

Determine whether any other new router hardware requires software or

PROM upgrades to work properly.

Note:

If you need help meeting the prerequisites of the Version 10.0 router

software upgrade procedure as described in this section, contact the Bay

Networks Technical Response Center in your area.

Note:

The PCMCIA/Floppy switch on a SYSCON-II Flash controller should

be in the Floppy position, with the router running Version 5.

software.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Keine Kommentare

Avaya Upgrading Routers from Version 5 to Version 10.0 Bedienungsanleitung Seite 14