Avaya Configuring IP, ARP, RIP, and OSPF Services Bedienungsanleitung PDF herunterladen (Seite 150)

Configuring IP, ARP, RIP, and OSPF Services

5-20

117356-E Rev 00

Specifying a Timeout Period

By default, RIP waits 90 seconds for an update from a network before it considers

that network to be unreachable. If you enabled dial-optimized routing on this

interface, the default is 3 hours.

You can use the BCC or Site Manager to specify a timeout period from 15 seconds

through 259,200 seconds (72 hours). For dial-optimized routing the maximum

value is 3,628,800 seconds (6 weeks).

You should set the timeout timer to a value equal to three times the value of the

update interval (see “

Specifying an Update Interval” on page 5-18).

Using the BCC

To specify the timeout period, navigate to a RIP interface prompt (for example,

box; eth 2/2; ip/2.2.2.2/255.255.0.0; rip

) and enter:

timeout-timer

seconds>

seconds

is the timeout interval in seconds.

For example, the following command sets the RIP timeout timer to 120 seconds

on IP interface 2.2.2.2:

rip/2.2.2.2#

timeout-timer 120

rip/2.2.2.2#

Using Site Manager

To specify the timeout period, complete the following tasks:

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

. The IP menu opens.

3. Choose

RIP Interfaces

. The IP RIP Interface Configuration

window opens.

(continued)

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 361 362

Keine Kommentare

Avaya Configuring IP, ARP, RIP, and OSPF Services Bedienungsanleitung Seite 150