
Using NetBIOS Services
114060 Rev. A 3-11
Enabling NetBIOS Services
This section describes how to enable NetBIOS services under source routing. It
assumes you have followed the directions in Chapter 2 to enable source routing
services.
To enable NetBIOS under source routing, open the Edit Source Routing Global
Parameters window (Figure
3-2) and change the default values of the NetBIOS
global parameters, as described in the following sections. Note that by default
NetBIOS is enabled on all interfaces. To disable NetBIOS on one or more
interfaces, edit the NetBIOS Interface parameters in the SR Interface List
(Figure
3-3) window as described in the following sections.
Refer to Chapter
2 for details on editing the source routing global parameters in
these windows.
Editing NetBIOS Parameters
Once you configure a circuit to support source routing, you use the Configuration
Manager to edit the NetBIOS parameters. This section describes how to access
and edit these parameters.
You access all NetBIOS parameters from the Configuration Manager Window
(Figure
3-1). (Refer to Using Site Manager Software for details on accessing this
window.)
Note: The instructions in this section assume that you already configured
source routing on the router. If you did not, refer to Configuring Routers for
details on configuring source routing.
Kommentare zu diesen Handbüchern