
Configuring Bridging Services
1-16 114060 Rev. A
When you enable spanning tree service, you need only configure the Bridge
Priority and Bridge MAC Address parameters. The Configuration Manager
supplies default values for the remaining parameters. If you want to edit the
default values, see “Editing Bridge P
arameters” later in this section.
3. Configure the parameters, using the descriptions that follow as a guide.
4. When you have configured the required parameters, click on OK.
A pop-up window prompts
Do you want to edit the Spanning Tree Interface Details?
5. Click on Cancel to enable default Spanning Tree service and display the
next protocol-specific pop-up window, or click on OK to edit the default
spanning tree values.
(Refer to “Editing Bridge P
arameters” for instructions.)
Note: Because the spanning tree is global (that is, it runs across all Bridge
circuits), the Configuration Manager only displays the Spanning Tree
Autoconfiguration window the first time you specify Spanning Tree for the
Bridge. If you have previously specified Spanning Tree for source routing, this
window will not appear. To change the parameter settings at a later time, refer
to the “Editing Bridge P
arameters” section.
Kommentare zu diesen Handbüchern