Avaya Configuring Bridging Services Bedienungsanleitung Seite 86

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 210
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 85
Configuring Bridging Services
2-26 114060 Rev. A
For each source routing parameter, this section provides information about default
settings, valid parameter options, the parameter function, instructions for setting
the parameter, and the Management Information Base (MIB) object ID.
The Technician Interface lets you modify parameters by issuing
set and commit
commands that specify the MIB object ID. This process is equivalent to
modifying parameters using Site Manager. For more information about using the
Technician Interface to access the MIB, refer to Using Technician Interface
Software.
Enabling Source Routing Services on an Interface
To enable source routing without spanning tree, use the following procedure.
1. Select Source Routing from the Select Protocols menu and click on OK.
The Select Protocols menu appears after you either select a link or net module
connector, or finish configuring a WAN circuit.
The Edit Source Routing Global Parameters window appears (Figure
2-14).
2. Specify the source routing bridge internal LAN ID and the source routing
bridge ID, using the descriptions that follow as a guide.
Caution: The Technician Interface does not verify that the value you enter for
a parameter is valid. Entering an invalid value can corrupt your configuration.
Note: Because source routing is global (that is, it runs across all Bridge
circuits), the Configuration Manager only displays the Source Routing Global
Parameters window the first time you specify source routing for the bridge. If
this window does not appear, source routing is already enabled on the bridge.
Seitenansicht 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 209 210

Kommentare zu diesen Handbüchern

Keine Kommentare