Avaya Configuring IP Multicasting and Multimedia Services Bedienungsanleitung PDF herunterladen (Seite 194)

Configuring IP Multicasting and Multimedia Services

A-24

303527-A Rev. 00

Parameter: Transmit Bcast Addr

Path: Select IP from the Select Protocols window and click on OK.

Default: 0.0.0.0

Options: 0.0.0.0 or any valid IP broadcast address

Function: Specifies the broadcast address that this IP subnet uses to broadcast packets.

Accepting 0.0.0.0 for this parameter specifies that the IP router will use a

broadcast address with a host portion of all 1s. Accepting 0.0.0.0 does not

configure the router to use the address 0.0.0.0 to broadcast packets. For

example, if you have IP address 123.1.1.1 and a subnet mask of 255.255.255.0,

accepting the default value 0.0.0.0 configures the IP router to use the address

123.1.1.255 to broadcast packets. To set the explicit broadcast address of all 1s,

enter 255.255.255.255 for this parameter.

Instructions: Accept the default, 0.0.0.0, unless the calculated broadcast address (host

portion) of all 1s is not adequate. If this is the case, then enter the appropriate IP

broadcast address in dotted-decimal notation. If you set the IP Address

parameter to 0.0.0.0 (to configure an unnumbered interface), Site Manager

automatically sets this parameter to 255.255.255.255.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.8

Parameter: UnNumbered Assoc Address

Path: Select IP from the Select Protocols window and click on OK.

Default: None

Options: Any valid IP address

Function: Specifies an address that IP uses when sourcing a packet. RIP uses this address

to make decisions about advertising subnets over the unnumbered interface. RIP

advertises subnets over the unnumbered interface if the subnets have the same

mask as the associated address.

Instructions: Specify the address of any numbered interface on the router. If you are running

RIP over the unnumbered interface and if you are using a subnet address as the

associated address, the local and remote associated addresses should have the

same network number. If you configure local and remote associated addresses

using different network numbers, you must use RIP2 mode.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.110

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 233 234

Keine Kommentare

Avaya Configuring IP Multicasting and Multimedia Services Bedienungsanleitung Seite 194