Avaya Configuring RADIUS Bedienungsanleitung PDF herunterladen (Seite 70)

Configuring RADIUS

C-6

303538-A Rev 00

Before You Begin

Before you begin, do the following:

Create and save a configuration file with at least one PPP interface.

Retrieve the configuration file in local, remote, or dynamic mode.

Specify the router hardware if this is a local-mode configuration.

Create a Backup Pool

To create a backup pool, begin at the Configuration Manager window:

Select an ISDN connector.

Site Manager displays the Port Application window.

Click on OK to accept the default for the Port Application Mode

parameter, Dialup 2B + D.

This configures the BRI interface. Repeat Steps 1 and 2 to configure

additional BRI interfaces.

Select Dialup > Backup Pools.

Site Manager displays the Backup Pools window.

Click on Add.

Site Manager displays the Backup Pools Configuration window.

Enter a pool ID, then click on OK.

Site Manager displays the Backup Lines Definition window.

Click on an ISDN connector to assign a line to the pool, following these

guidelines:

• Site Manager does not allow you to select any lines that you configured as

leased lines.

• Lines in a backup pool may reside across slots.

Site Manager displays the ISDN Switch Configuration window.

Click on Done to accept the parameter defaults.

Site Manager displays the ISDN Logical Lines window.

Click on OK to accept the parameter defaults.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76 77 78

Keine Kommentare

Avaya Configuring RADIUS Bedienungsanleitung Seite 70