Avaya Configuring RADIUS Bedienungsanleitung PDF herunterladen (Seite 71)

Configuration Examples

303538-A Rev 00

C-7

You return to the Backup Lines Definition window. The letter B (backup)

appears next to the ISDN port to indicate that it is a backup line.

Select File > Exit to exit the Backup Lines Definition window.

You return to the Backup Pools window, which has three new buttons (Edit,

Apply, and Delete) that allow you to edit the new pool.

10.

Repeat Steps 3 through 9 to select additional lines for the pool.

11.

Click on Done to return to the Configuration Manager window.

Create a Dial Backup Circuit

To create a PPP backup circuit, begin at the Configuration Manager window:

Select Backup Circuits > PPP.

Site Manager displays the Primary Circuit Definition window, which lists the

leased circuits that you have configured.

Select a circuit entry and click on Cct Type.

Site Manager displays the Circuit Options window.

Enter Primary for the Circuit Type parameter.

Enter the ID of the backup pool that this circuit should use.

Click on OK.

You return to the Primary Circuit Definition window, which shows the

parameter defaults supplied by Site Manager.

Repeat Steps 2 through 5 to specify additional primary circuits.

Scroll down the Primary Circuit Definition window to the Backup Mode

parameter.

Select a value for the Backup Mode parameter. The default is Master.

If this router is the master router, the peer router’s backup mode must be set to

Slave. If you set the backup mode to Slave, Site Manager prompts you for

caller resolution information so the slave router can verify the identity of a

remote caller.

Refer to Configuring Dial Services for more information about dial backup

circuits.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 77 78

Keine Kommentare

Avaya Configuring RADIUS Bedienungsanleitung Seite 71